axial motion

英 [ˈæksiəl ˈməʊʃn]

美 [ˈæksiəl ˈmoʊʃn]

网络  轴向运动

英英释义

noun

• rotary motion of an object around its own axis
  1. wheels in axial rotation
  Synonym:axial rotationroll

双语例句

• Wind-induced Vibration Control of Cable by Axial Support Motion
  支座轴向运动控制拉索风致振动的研究
• The research on the large-amplitude vibration suppression of stayed cable under wind excited by controlling support axial motion was carried out in this paper.
  主要研究通过对拉索支座的轴向运动进行控制以减小风荷载作用下拉索振动。
• The axial movement of materials in the low-speed cylinder is analyzed and the motion formulae are reached in this paper.
  本文分析了慢速滚筒内物料的轴向运动，导出了轴向运动的计算公式。
• Preoperative and postoperative Japanese Orthopedic Association ( JOA) scores, the degree of axial symptom, ranges of neck motion, cervical curvature index were recorded and compared.
  对两组患者手术前后的JOA评分、颈椎曲度指数、颈椎活动度及轴性症状严重程度进行比较评估。
• Axial piston pump is through the reciprocating motion of the piston to achieve oil suction and extrusion.
  轴向柱塞泵是通过斜盘推动柱塞往复运动来实现泵的吸排油过程和系统压力的建立。
• As for F2, it partially disappeared and then the rest showed horizontal axial motion, and eventually erupted wholly. ( 2) The eruptive mechanisms of the two filaments are different.
  而暗条F2一部分先消失，其余部分出现水平的轴向运动，最后F2整体爆发。
• According to the definition of the angular momentum, the paper discusses any axial angular momentum of plane motion of rigid body, and works out the theorem of rotation of axis of center-of-mass and instant center in plane motion of rigid body.
  从角动量的定义出发，计论了刚体平面运动时对任一定轴的角动量，推出了刚体平面运动时对质心轴、瞬心轴的转动定理。
• The bearing pin is provided with a retaining bolt at end for preventing axial motion.
  为防止承重销轴轴向移动，在其端部安装止挡螺栓。
• With regard to the nonlinear vibration of an axially compressed cylindrical shell subjected to axial or radial disturbance, two kinds of nonlinear motion equations of cylindrical shell are obtained by adopting Donnell-K á rm á n large deflection equations or logarithmic circumferential strain definitions, respectively.
  对于轴压圆柱壳经受轴向和横向扰动时的非线性振动，分别采用Donnell-Kármán大挠度理论和环向对数应变建立了两种非线性运动方程。
• The conclusions are drawed as follows: ( 1) The modification of the tooth surface must be done for decreasing the impact while oscillating teeth doing the axial reciprocating motion in the process of end face harmonic gear drive.
  在活齿端面谐波齿轮传动的过程中，为了减小啮合副中的活齿作往复直线运动时的惯性冲击，必须对各啮合副的理论齿面进行修形。